Quantcast
Channel: ToManual.com » Search Results » touch up paint
Viewing all articles
Browse latest Browse all 10

Acura TSX ONE TOUCH SUNROOF MODULE INSTALLATION MANUAL

0
0

Download (Honda Accord/Acura TSX). INSTALLATION: 1. Access the wiring on the back of the sunroof control switch. For most Hondas/Acuras this involves removing the panel directly under the steering wheel and the plastic piece under the dash. It should then be possible to push the sunroof switch pod out of the dash from behind. 2. Secure the module behind the dash panel using the included wire ties. 3. Locate a switched ignition source – this typically can be found at the ignition switch. ELECTRICAL CONNECTIONS: Due to the harsh environment found in vehicles, KP Technologies recommends always soldering and securely taping EVERY connection. In order for the “One Touch” feature to work with the “VENT” position of the sunroof it is necessary to install two diodes. To install the diodes the “OPEN” and “CLOSE” sunroof wires must be cut. If the “One Touch” feature is only required for the “OPEN” and “CLOSE” it may not necessary to cut any wires (depending on the installers method of splicing). 1. GREEN – SUNROOF OPEN (Typically gray with sky blue stripe) a. Locate the Sunroof Open wire. This wire will read 12vdc under normal conditions and 0vdc for the duration of the open button being pushed. b. If installing diodes cut this wire approximately 4″ from the plug. c. Connect the striped side of the diode and the GREEN wire from the “One Touch” sunroof module to the plug side of the Sunroof Open wire. d. Connect the non-striped side of the diode to the sunroof motor side of the Sunroof Open wire. e. If not using diodes simply connect the KPtechnologies GREEN wire to the Sunroof Open wire. 2. BLUE – SUNROOF CLOSE (Typically light green with black stripe) a. Locate the Sunroof Close wire. This wire will read 12vdc under normal conditions and 0vdc for the duration of the closed button being pushed. b. If installing diodes cut this wire approximately 4″ from the plug c. Connect the striped side of the diode and the BLUE wire from the “One Touch” sunroof module to the plug side of the Sunroof Close wire. d. Connect the non-striped side of the diode to the sunroof motor side of the Sunroof Close wire. e. If not using diodes simply connect the KPtechnologies BLUE wire to the Sunroof Close wire.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images